One for All Universal Remote Codes & Setup Guide

One For All remote control is more compatible with almost every brand of TV, Cable, DVD, Blu-ray, Media player, Game Consoles, and Audio devices.

Before using this. You need one for all remote codes to enjoy seamless control on all your devices. So check our complete list of codes,

Also, we have written three different “one for all remote code search methods” that you can use to set up the remote with the devices.

One For All Universal Remote Codes For Sinotec TV

One For All Universal Remote Codes For Vizio TV

One For All Universal Remote Codes For Philips TV

One For All Universal Remote Codes For Toshiba TV

One For All Universal Remote Codes For LG TV

How to Program One For All Universal Remote Without Codes

Through this method, all universal remote codes are scanned through the remote. Scanning each code one at a time, it finds the correct remote code that works with your remote control. To do this, follow these steps

1. “Switch On your TV” or any other device you want to use with your remote.
2. Now “Turn on” your remote and press the Device button (TV, DVD, CBL, and OK/SEL) for at least 3 seconds.
3. You’ll see a LED light blink, which means the device is ready to program.
4. Place the remote near your device and click on the “CH+” & “CH-” buttons.
5. A remote will display the on/off signal.
6. You must continue pressing the “Up” or “Down” key until you see the device turn off.
7. Click the “Power” key to verify the code.
8. The device should now “Turn On”. If the TV starts, you need to change the channel in order to verify that the programming is correct.
9. Now “Press the device key” to store the code.
10. You will see the “Two blinks of the LED” on the remote which means the code is successfully stored.

How to Program One For All Universal Remote With Manual Method

You can program the universal remote using the keycode, which identifies the model and makes of your equipment.

1. Start with “Turn On” the device.
2. Click on the “TV key” from your remote
3. Keep pressing the “Setup Button” for a few seconds until it shows the “Light Blink”.
4. Enter the keycode that you pick from the top list.
5. When it’s done just bring your remote to the device and then hold the “Power Button”.
6. Once you see the screen is off, you can release the “Power Button”.

Now all is done. The universal remote control will now work perfectly on your TV. If it doesn’t work, try again with the next code in the reference table.

One For All Remote Setup With Code Search

In case the two previous methods did not work, you can try this one and set up your all-in-one universal remote with code search. The manual has a code that enables the remote to search.

• First, “Turn On” the device
• Keep Press or Hold the “SETUP” key
• Enter the three-digit code “9-9-1”
• Now hold the “Power Button”, and press the “Channel Up” key at the same time.
• Your TV should “Turn off”.

You may have to spend a little extra time searching for the key code with the above method. After you complete the above steps, your remote should work with all the features.