oCOSMO Universal Remote Codes & Setup Guide

Do you have an Ocosmo system? Would like to use a universal remote control to operate it. Here we provide all codes and programming information, where you can find many codes that manage your device perfectly.

You will find Ocosmo universal remote codes listed as either three-digit or four-digit numbers, but if you own the newest brand version of the universal remote, 5 digit codes are also available. You can check all the codes list and program setups below to easily program your device.

Ocosmo Universal Remote 5 Digit Codes

OCOSMO TV 4 digit Remote Codes

Here are the steps for programming your universal remote to pair with Ocosmo TV.

All methods are perfectly working for the Ocosmo system that we updated below.

By changing the remote code from the Ocosmo tv remote codes list can be helpful if one method does not seem to work well for your universal remote.

How to Program Ocosmo Universal Remote Without Codes

The universal remote codes are scanned during the auto search process in the remote. To program your remote, the program scans one code at a time. To proceed, follow these steps:

• “Turn On” the smart device.
• Tap on the device button by the remote only for 3 seconds. A LED light will appear that indicates the device is ready to program.
• Take the remote in the direction of Tv then press on the “CH+” & “CH-“ keys. On and Off signals will show.
• Continuously click on the “up” or “down” key and then the device will turn off.
• Recheck the code by selecting the “Power” key. The system will start. Check the Remote is programmed by changing its channels.
• For saving the code tap the “Device” button.
• LED will flash two times to confirm that the code has been stored.

How to Program Ocosmo Universal Remote With Manual Method

The keycode identifies the model of your device so that we can easily program a universal remote control.

• Switch On a smart device like Tv.
• Select Tv from your “Ocosmo universal remote”.
• Push the “Setup button” of the Universal Remote until it represents the “Flash Light”
• Write the “Keycode” which you collected from the codes list.
• Point your remote at the TV after this procedure
• Hold and click the Power button.
• When the screen switches off release the “Power Button”.

If your TV is still not working with the universal remote control, try repeating the same procedure with a different code.

How to Program Ocosmo Universal Remote With Code Search

In this process, you can easily search for the correct code by using the search mode. If you were unable to find the correct code with the above method you can try this one now. Its a code in the manual which forces the remote into the search mode

• Start the device.
• Push the Setup button for a while.
• Type the “9-9-1” code.
• Press the “Power Button” on the remote.
• Click on the Channel up button until the smart device like Tv “Turns Off”.

While finding your key code may take a little more time than the above two methods. Your remote should now work its all functions after completing the above steps.

Conclusion

Thank you for visiting our website. After focusing on this article, I try my best to provide all Ocosmo universal remote setup detail hope so it will be helpful for you. You keep checking the codes until your device is done with your favorite universal remote control. If you require any remote code are any issue with that so please leave a comment here and also share your experience with your buddies.